GENERAL APPLICATIONS & USE GUIDANCE
Hyperox’ unique formulation, broad spectrum of activity and enhanced stability make it the peracetic acid disinfectant of choice for farm; general surface, equipment, water delivery system and thermal fogging disinfection.
APPLICATION & USE GUIDANCE
|Surface Disinfection||Dilution rate||Application|
|Routine disinfection for all pre-cleaned surfaces including wood and concrete||1:100 (10ml of Hyperox™ concentrate to 1 litre of water)||Using mechanical spraying equipment, apply Hyperox™ solution at an application rate of 300ml/m2.|
Example: Routine disinfection of a 1000m2 house, with a total surface area of 2500m2 including walls and ceiling, at a dilution rate of 1:100 and an application rate of 300 mls/m2 or to point of run-off, will require a solution consisting of 7.5 litres of Hyperox™ concentrate added to 750 litres of water. This calculation is based on typical UK conversion rates: please check your country/regional specific requirements.
|Equipment Disinfection||Dilution rate||Application|
|Routine disinfection of clean movable equipment||1:100 (10ml of Hyperox™ concentrate to 1 litre of water)||Spray all equipment with Hyperox™ solution to point of run-off.|
|Disinfectant Foot & Wheel Dips||Dilution rate||Application|
|Routine disinfection of clean movable equipment||1:100 (10ml of Hyperox™ concentrate to 1 litre of water)||Replace solution once it has either become soiled or after a period of 2 days.|
All water systems contain some microbial contamination, especially header tanks where dust and debris can accumulate. Disinfecting will clean the system and eliminate waterborne pathogens, including bacteria and viruses.
|Water System Disinfection||Dilution rate||Application|
|Terminal disinfection of water systems||1:100 (10ml of Hyperox™ concentrate to 1 litre of water)||Isolate header tank at the mains and drain system. Clean out any gross soiling and debris. Refill with clean water and add the appropriate volume of Hyperox™ concentrate, stir thoroughly and leave for 1 hour. This will help remove biofilm from the inner surface of the drinking water system. Flush system through and refill with clean water.|